Super Leveler Instructions

The xTool RA2 Pro Rotary comes with 2mm and 2.5mm hex drivers; you will need these for installation.

Do not over-tighten the screws, as it does not take much to hold them in place.

Step 1 - Using a 2mm hex driver, remove the two M3x35mm screws that hold the RA2 Chuck to the base plate. Store these somewhere safe; they will not be needed for the Super Leveler.

Step 2 - Slide the super leveler onto the base plate. Ensure the locking tab is aligned as shown as you slide it on. Position it most of the way to the right.

Step 3 - Lightly Tighten the locking tab just enough so that the Super Leveler doesn't slide when the base is tilted.

Step 4 - Using a 2.5mm hex driver, remove the M3x40mm screws from the top of the Super Leveler. Place the RA2 Chuck on top, align the holes, and reinsert the screws. Lightly tighten the screws.